상세검색
최근 검색어 전체 삭제
다국어입력
즐겨찾기0
학술저널

COVID 19 유행에 따른 컨테이너를 이용한 선별 X-선 검사실의 안전성에 대한 고찰

A Study on the Safety of a Screening X-ray Laboratory Using Containers in accordance with the COVID 19 Outbreak

  • 66
153190.jpg
※해당 콘텐츠는 기관과의 협약에 따라 현재 이용하실 수 없습니다.

COVID-19로 인해 수출용 컨테이너에 방사선 발생 장치를 설치한 경우 방사선실의 공간선량을 측정하고 검사실 내의 차폐벽의 효용성에 대하여 연구하고자 하였다. 측정 지점은 X-선관에서 검사자가 있는 뒤쪽으로 이동식 차폐벽을 사용하지 않았을 때를 12곳을 측정하였으며, 이와 대조군으로 이동식 차폐벽을 사용한 후 차폐벽 뒤에서 3곳을 측정하였다. 측정은 Survey Meter를 켜고 배후 방사선(Background)을 측정하였고, 배후 방사선(Background)에서 측정 Peak치 값을 빼서 산출하였다. 이동식 차폐벽 없이 X-선관 뒤, 50cm, 100cm, 200cm로 설정하여 12 곳을 측정하였고, 이동식 방사선 차폐벽을 사용하여 X-선관 뒤에서 3곳을 측정하여 이동식 방사선 차폐벽의 사용 전후의 선량값을 비교하였다. 이동식 차폐벽의 사용 여부에 따라 측정된 선량의 평균값을 대응표본 t 검정을 통하여 결과값 p < 0.05(양측)로 검증하였다. 측정값은 X-선관 뒤 좌측 50cm : 1.446μSv, X-선관 뒤 : 0.545μSv , X-선관 뒤 우측 50cm : 1.466μSv, 방사선 방어용 벽 뒤에서 측정값은 0.190μSv, 0.204μSv, 0.191μSv였다. 실측한 결과 검사실 내에서의 차폐벽으로 인한 검사자의 의료 피폭은 82.3%로 감소시킬 수 있었다. 선별 방사선 검사실에서의 직업 피폭을 감소시키기 위해서는 방사선 발생원으로부터 충분한 이격과 차폐벽의 사용을 권고하는 바이다.

When a radiation generating device is installed in an export container due to COVID-19, the purpose of this study was to measure the space dose in the radiation room and to study the effectiveness of the shielding wall in the laboratory. Air dose measurement method was set behind the X-ray tube, 50 cm, 100 cm, 200 cm, and measured 12 locations. The dose values before and after the use of the movable radiation shielding wall were compared by measuring 3 locations behind the X-ray tube using the movable radiation shielding wall. The measured values were 50 cm on the left behind the X-ray tube: 1.446 μSv, behind the X-ray tube: 0.545 μSv, and 50 cm on the right behind the X-ray tube: 1.466 μSv. Measurements behind the radiation barrier were 0.190 μSv, 0.204 μSv, and 0.191 μSv. As a result of performing the corresponding sample t test of the average value according to the use of movable barrier walls, p <0.001 was found. As a result of the actual measurement, the medical exposure of the examiner due to the shielding wall in the laboratory decreased to 82.3%. In order to reduce occupational exposure in screening radiological laboratories, it is recommended that sufficient separation from radiation sources and the use of shielding walls are recommended.

Ⅰ. INTRODUCTION

Ⅱ. MATERIAL AND METHODS

Ⅲ. RESULTS

Ⅳ. DISCUSSION

Ⅴ. CONCLUSION

Reference

(0)

(0)

로딩중