Double Side SMT and Molding Process Development for mPossum Package
- 한국마이크로전자및패키징학회
- 마이크로전자 및 패키징학회지
- 제23권 제4호
- : KCI등재후보
- 2016.12
- 43 - 48 (6 pages)
3-Dimensional System in Package (3-D SiP) structure (Amkor calls it mPossum-molded Possum) using double side Surface Mount Technology (SMT) and double side molding was evaluated in order to achieve small/thin form factor as well as good functionality by integration and double side layout. As the new platform on laminate substrate basis, molding process was challenge in mold flow balance at top and bottom side and package warpage control over the overall assembly process. There were two types of different molding process evaluated with 1) 1-step molding which was done at both side at the same time and 2) 2-step molding which was done at the conventional molding process twice. Mold simulation helped to narrow down the material selections and parameters available before actual sample build. There were many challenges for this first trial in design/ parameter and material types but optimized them to enable this structure.
1. Introduction
2. Experiment Procedure and Results
3. Conclusion
References